Skip to content

We may be paid when you buy through our links. Who pays us never changes what we show. How we make money

Explainer6 min read

How many watts a pellet grill uses: startup vs running

What Traeger, Pit Boss and Green Mountain Grills manuals say about pellet grill watts, amps, inverters, GFCI outlets and running one off a power bank.

On this page
  1. The short answer: about 250 watts, with a spike at startup
  2. Why the first few minutes draw the most power
  3. Rated watts and amps by brand and model type
  4. Running a pellet grill from a power bank, inverter or car
  5. Outlets, GFCI trips, fuses and power cuts
  6. What to check next

The short answer: about 250 watts, with a spike at startup

Two popular full-size pellet grills, the Traeger Pro 22 and the Pit Boss PB600PS1, are both rated at 250 watts 24, and Traeger says power use drops significantly once the grill reaches its set temperature 1. Traeger lists its Pro 22 as a 120V AC grill that uses 250 watts 4. Pit Boss gives its PB600PS1 the same 250W rating on a 110-120 volt, 60hz supply 2. The peak comes right after you press start: the Pit Boss manual says the ignitor draws 200-700 watts during the start-up phase 2. Once the grill holds temperature the load falls a long way, and Traeger says its non-WiFIRE grills drop to 0.4-0.8 A after heating 1.

This page covers what Traeger, Pit Boss and Green Mountain Grills manuals say about watts, amps, inverters and outlets, as of November 2026 1. It does not cover pellet use per hour, which has its own page: how many pellets a pellet grill burns per hour.

Why the first few minutes draw the most power

A pellet grill is an electric appliance wrapped around a wood fire. The electricity never cooks the food. It runs key parts such as the controller, the fan and the auger motor, which is how Traeger describes what its grills power 1. The igniter is a heating element that only runs at startup, and it is why the startup number is so much higher than the running number.

Green Mountain Grills prints the whole startup sequence for its Trek Prime 2.0 in the owner's manual 3. The auger runs first for 55 seconds to push pellets into the firebox 3. The igniter then heats the pellets for 90 seconds 3. After that the combustion fan joins the igniter for two 30 second stages to light the pellets and prove the fire 3. From a cold start the manual says it takes about 15 minutes to reach the temperature you set 3. The igniter is off well before then: the manual says the board turns it off once the grill makes proof of fire, which it defines as 5 degrees above ambient temperature 3.

Pit Boss explains the same effect from the outlet's point of view. The manual says this about GFCI outlets:

During the start-up phase, the ignitor draws 200-700 watts of electricity which can be too much power for a GFCI outlet to handle.

Pit Boss Grills (Dansons), Pit Boss PB600PS1 Wood Pellet Grill & Smoker owner's manual2

Traeger's support page makes the same two points in general terms: grills use more power when starting up and heating, and after reaching the set temperature power use drops 1.

Rated watts and amps by brand and model type

Traeger publishes a power table by grill family, with watts and the matching amps at 120V 1. Its non-WiFIRE grills are listed at 300W, or 2.5 A 1. The D2 generation is rated at 110W, or 0.9 A, and drops to 0.08-0.17 A once heated 1. The Woodridge is rated at 535W, or 4.5 A 1. The big numbers belong to add-ons, not the smoker itself: a touchscreen grill with the induction cooktop is listed at 1756W max, or 14.6 A, and Traeger notes it may need a dedicated circuit 1.

Pit Boss states one figure for the PB600PS1: 110-120V, 60HZ, 250W, with a 3-prong grounded plug 2. Traeger's Pro 22 product page matches it at 250 watts, and that model has no WiFIRE connectivity, so it sits in the 300W non-WiFIRE family on the support table 14. Two Traeger pages, two slightly different numbers for the same kind of grill. The support table's 300W figure is the one it says drops to 0.4-0.8 A after heating; the product page does not say which phase its 250 watts describes 14.

Green Mountain Grills takes a different route. Its Trek Prime 2.0 accepts 110-240 VAC at 50/60 Hz through an adapter but ultimately runs on 12V direct current 3. The manual rates the grill at 2-145W 3. For other small grills, see our portable pellet grill comparison.

Running a pellet grill from a power bank, inverter or car

A small power bank can keep a pellet grill running, but it may not be enough to light one. Pit Boss spells this out in a section called On the Road. With the igniter unplugged from the wiring harness and the fire lit by hand using the manual start-up procedure, a Pit Boss can run from a 12 volt, 100 watt inverter in a car outlet 2. To use the automatic igniter instead, Pit Boss recommends a minimum of a 1000 watt inverter 2.

Traeger's watt and amp page does not give inverter sizes 1. Its guidance is to plan for the maximum amp usage, and its FAQ says a generator works as long as it supports the required wattage or amps 1. The support page also gives the formula for converting between the two: amps equal watts divided by volts 1. For a 120V grill, that means the 300W startup figure for a non-WiFIRE Traeger is the 2.5 A the table shows 1.

Green Mountain Grills builds the 12V option into the grill 3. Because the Trek runs on 12V direct current, the parts list includes an AC adapter for wall power and alligator clips sold for all its 12V grills 6. The manual says you can connect either a 110V/220V or 12V plug 3. None of the three pages reviewed here gives hours of runtime for a given battery, so that is a number to measure or estimate from the watt figures above.

Outlets, GFCI trips, fuses and power cuts

At home the question is usually not watts but whether the outlet will trip. Pit Boss says its grill works on most GFCI outlets and recommends a 15 amp service 2. A sensitive GFCI will likely trip during startup, and the manual warns that each time it trips, it increases in sensitivity 2. If it keeps tripping, the manual's fix is to replace the outlet or move to a non-GFCI one 2. Pit Boss's Canadian FAQ adds a cause: if the GFCI is tripping, many times it is the igniter that needs to be replaced 5. Traeger says a breaker is not likely to trip if you are under 15-20 amps on the common 15A or 20A home circuits 1.

Pit Boss also protects its control board with a 110-120 volt fast-blow fuse between the board and the igniter 2. If it blows, the FAQ says a replacement is a 5-amp, 250-volt, fast acting fuse available at many local retailers 5. On the Green Mountain side, the troubleshooting page for a grill that will not turn on starts with the basics: check the cord, the ON-OFF switch underneath the back of the hopper, and the circuit breaker or GFCI the adapter is plugged into 3.

A pellet grill depends on power for its fan and auger, so a power cut in the middle of a cook is its own problem 1. Green Mountain describes a bypass mode for hot restarts, meant only for when power is lost while a fire is still in the grill 3. It works if some fire is left in the firebox, which the manual says is usually no longer than about 6-7 minutes after the power went out 3. For cold starts in winter, see pellet grills in cold weather.

What to check next

  • Your own grill's rating plate or manual: look for the line that reads like 110-120V, 60HZ, 250W and note whether it also gives a startup or igniter figure 2.
  • Traeger owners: the support article Grill Watt & Amp Usage lists watts and amps by grill family at 120V and 240V, and says which add-ons may need a dedicated circuit 1.
  • Pit Boss owners: the Connecting to a Power Source section of your manual, for the GFCI, inverter and manual start-up notes for your model 2.
  • Green Mountain owners: the Grill Power Specs and Understanding the Startup Cycle pages in the Trek manual, and the Trek parts list for the AC adapter and 12V alligator clips 3.
  • Any power station or inverter you plan to use: its continuous watt rating and its peak rating, compared against the startup figure for your grill, and whether its outlet is GFCI protected.

Sources

  1. Grill Watt & Amp UsageTraeger Support, read Nov 4, 2026
  2. Pit Boss PB600PS1 Wood Pellet Grill & Smoker owner's manualPit Boss Grills (Dansons), read Nov 4, 2026
  3. TREK PRIME 2.0 Owner's ManualGreen Mountain Grills, read Nov 4, 2026
  4. Traeger Pro 22 Pellet Grill BronzeTraeger Grills, read Nov 4, 2026
  5. Pit Boss FAQPit Boss Grills Canada, read Nov 4, 2026
  6. TREK PARTSGreen Mountain Grills, read Nov 4, 2026

We may be paid when you buy through links on this page. How we make money